JIS Standard Stainless Steel Mold Spring and Die Spring with 5 Load Classes for Automobile Tooling
10mm ID Round Wire Springs
,20mm OD Coil Compression Springs
,Carbon Steel Compression Coil Springs
MOLD SPRING - JIS Standard Stainless Die Springs, 5 Load Classes
Japanese tooling is dimensioned to JIS, and the load class is what decides whether the stripper plate returns cleanly or the part gets marked. This listing covers the full range: one JIS dimension system, five colour-coded classes, so one pocket accepts any class without remachining.
Why this JIS range
- Five load classes, one dimension system: yellow (light), blue (medium), red (heavy), green (extra-heavy) and brown (super-heavy) all share the JIS series, so a class change never changes the bore.
- JIS dimensions, drop-in fit: outer diameter, free length and installed height follow the JIS series used in Japanese tooling, so a replacement goes straight back into the existing pocket.
- Rectangular wire, ground flat ends: more force per millimetre of installed height than round wire, and flat ends keep the stripper plate parallel through the stroke.
- Stainless steel body: resists rust in humid tool rooms, after wash-down, and in food, medical and cleanroom moulding.
- OEM sizes to drawing: non-standard diameters and free lengths are produced from your drawing, sample or original Japanese part number.
How to pick the class
Light stripper force on thin or cosmetic parts calls for yellow. General blanking and piercing calls for blue. Thick stock and high stripping force calls for red. Very heavy blanking and high-cycle tools call for green or brown. When replacing, match the old colour first, then confirm free length and diameter.
Specifications
- Material: stainless steel, rectangular-section wire
- Standard: JIS dimensional series
- Load classes: yellow light, blue medium, red heavy, green extra-heavy, brown super-heavy
- Sizes: metric JIS sizes; custom to drawing
- Ends: closed and ground flat
- Finish: pre-set, stress relieved
- Packing: export carton, anti-rust bag
Installation and care
- Match the original colour code or part number before ordering; JIS and ISO series are not always interchangeable.
- Check hole and rod clearance against the JIS table; a spring rubbing the bore loses force and fails early.
- Never compress beyond the maximum deflection for the size; over-travel collapses the spring.
- Replace as a matched set and keep the bore lightly lubricated.
Shipping and returns
- Samples accepted so you can confirm class and fit first.
- Load class, size and quantity confirmed on the quote; lead time given per order.
- Any deviation from the confirmed drawing is replaced at our cost.
Please Use Our Online Inquiry Contact Form Below If You Have Any Questions, Our Team Will Get Back To You As Soon As Possible