ISO 10243 Stainless Steel Mold Spring and Die Spring with Left Hand Helical Direction for Industrial Compression Use
OEM Size Compression Coil Spring
,Industrial Stainless Steel Compression Coil Spring
,JIS Standard Stainless Steel Compression Spring
Why toolmakers specify ISO 10243 mold springs
A die spring has one job it cannot fail: push the stripper plate, ejector plate or slide back to its exact start position, cycle after cycle, without fading. When a spring loses force, parts stick, slugs jam and the press goes down. These springs are built to stop that from happening.
Coiled from 50CrV4 chrome-vanadium wire, stress-relieved, shot-peened and pre-set, every spring is ground flat at both ends so it seats square in a bored pocket - no cocking, no side load, no cracked coils. Four ISO colour codes let anyone on the shop floor read the load rating at a glance: yellow for light, blue for medium, red for heavy and green for extra heavy.
What you get
- Load that stays put - pre-setting removes the initial set that makes untreated springs shed force in the first few hundred cycles
- One bore, four forces - light through extra heavy share the same pocket diameter, so you can re-tune a tool without re-machining it
- 50CrV4 or SUS304 - chrome-vanadium for general stamping and molding, stainless where humidity, wash-down or cleanroom conditions demand it
- Metric sizes to JIS B5012 - straight swaps for Japanese and European die sets
- Flat-ground closed ends - square seating, full contact area, longer tool life
- Singles, 10-packs or assorted kits - stock the sizes that actually break on your press
How to pick the right spring
- Measure your pocket and guide-rod diameter. The spring's rod diameter matches the rod, not the hole.
- Pick the load colour for the job: light for strippers and small ejectors, medium for general work, heavy and extra heavy for high-pressure forming and thick-material blanking.
- Check the deflection. Never compress past the rated working deflection of that colour class - over-deflection is the single biggest cause of spring failure.
Care and fitting
Keep the guide rod clean and lightly lubricated, deburr the pocket before fitting, and replace springs as a set rather than one at a time so the plate stays level. Springs are a wear part: with a spare set on the shelf you will never hold a press for a two-dollar component again.
Standard range is shown in the specification table. Send us your bore, free length and required force and we will match the exact part and load class.
Please Use Our Online Inquiry Contact Form Below If You Have Any Questions, Our Team Will Get Back To You As Soon As Possible